All About Tool

The lever you’re probably referring to on back of your tape measure is the anti-kickback pawl; it’s what clicks and locks the blade into place … Read more

Cinder block walls is tough, right? But they can be surprisingly difficult to attach anything too. Before you know it, you’re grabbing your drill and … Read more

When you hear the blade grinding against metal, it’s a red flag. The teeth has dulled or the diamond finish has been ground away to … Read more

When drilling into a dowel, you often gets frustrated with bit sliding sideways. This results in an off-center hole, which is not good for joining … Read more

There’s something you fear that goes “thud” instead of “slice.” You pull up to make the cut, get lined up, press the trigger…and nothing works. … Read more

When your go-to DeWalt gear finally gives up the ghost there’s a particular kind of letdown: Your cordless drill die after a few years of … Read more

I am talking about a specific look, where the floor have gone from shiny to hazy and the polishing pad has become a useless brick … Read more

Wood dust is very fine. It gets into cracks, lands on shop floor, and turns everything slippery. Most people believe their typical vacuum or a … Read more

Go to your local big box store. Walk down the aisle where all of Ryobi power tools is sitting on the shelf, brightly colored, nicely … Read more

A circle… It sounds so easy, just drill a hole right there in the middle. But then you get out your drill and it slide … Read more