How To Change a Drill Bit Without a Chuck Key? (3 Steps)

how to change a drill bit without a chuck key
how to change a drill bit without a chuck key

Keeping your unit perfectly organized can help you avoid many issues in the long run. It is quite common to see users struggling with missing chuck key and drill bits. This can directly impact the efficiency of a project. So, the best way to go about fixing this problem is by managing a separate toolbox for your drilling unit.

With that said, a ton of users have recently come forward with questions about how to change a drill bit without a chuck key. If you’re in a similar situation and can’t seem to find your chuck key, then the following solutions should help you.

How To Change a Drill Bit Without a Chuck Key? 

1. Rotate the Chuck

If the drill bit is not lodged into your unit, then you can fix this issue quite easily by rotating the chuck in an anticlockwise direction. All you have to do is hold the handle of your drill in one hand and start rotating the chuck with the other. A small amount of force should be enough to manage the issue with your drill bit.

Once the hold of the chuck loosens up, you can take the drill bit out and then put in the new bit in your drill. After adding your new drill bit to the unit, just rotate the chuck in a clockwise direction, and that should tighten up the new drill bit in its proper location.

2. Use Reverse Rotation

If you’re unable to get the drill bit out of the unit with your bare hands, then you can rely on the drill action to accomplish this task. All you have to do is hold down the chuck with a set of pliers firmly. After the check is secured in its position, just turn the drill in reverse rotation.

If you’re lucky, then the drill bit will come out immediately, and you won’t have to bother with increasing the torque of your unit. However, if you can’t seem to get the drill bit out with low torque, then crank up the power, and that should be enough to loosen up the drill bit. After the drill bit is released, you can easily add in the new drill bit and run the drill in a clockwise rotation to tighten it.

3. Use Drill Bit

Using a drill bit is another method that can be used to get around this problem. So, if you don’t want to force out the drill bit, then try to find a drill bit in your toolbox that fits inside the chuck keyhole. That way, you can use this drill bit as a substitute chuck key to loosen up the hold over the current drill bit.

After that, simply take out the old drill bit and add the new drill bit into the unit. At this stage, just add your new drill bit to the chuck and use the substitute drill bit to tighten up the hold again. Hopefully, these methods will help you through your project if you are not aware of how to change a drill bit without a chuck key.

Leave a Comment